Turn a steering wheel against the stop counterclockwise.
At turn of a steering wheel do not make great efforts.
Remove an engine support arm.
Remove a pulley of the water pump.
Remove the top casing of a gear belt.
Remove the lower casing of a gear belt.
Rotate a bent shaft only clockwise.
Turn a bent shaft clockwise and combine adjusting tags that the piston in the first cylinder was installed in the top dead point in a compression step.
Weaken a bolt from a point of turn of the mechanism of a tension and a bolt from outside a vent.
Turn a bent shaft clockwise on full 2 teeth on a pulley.
For the correct adjustment of a tension establish a yoke of the final valve in the top provision of a cam.
Make sure that teeths of a pulley and a gear belt coincide.
First of all tighten a bolt from outside a vent and in the second turn – a bolt from a point of turn of the mechanism of a tension.
Establish a tension of a gear belt.
Establish the lower casing of a gear belt.
Establish the top casing of a gear belt.
Establish a pulley of the water pump and an arm of a support of the engine.