18:15. Multipurpose switch
Removal and installation
At removal of the multipurpose switch on the cars equipped with a safety cushion be careful and satisfy the following conditions.
|
|
- Do not sort any of components of an auxiliary security system of SRS. Dismantling of components can put a security system out of action.
- Exclude hit on a safety cushion of solvents or the clearing substances.
- Transport the safety airbag separately, a bag up.
- If any SRS component fell or on it there are cracks, dents or other defects in the case, an arm or the socket, replace them with new.
- When transporting do not place a hand on a safety cushion.
- Do not heat the safety cushion block to temperatures above 93 °C.
- After expansion of a safety cushion replace a spiral spring of the sensor with new.
- Before installation of a spiral spring of the sensor of a safety cushion combine a tag and the index of neutral provision of a spring of the sensor, previously having established forward wheels for the movement directly forward. If the tag of a spiral spring is not combined properly, the steering wheel will not be able to turn completely or the wire of a spiral spring will be damaged, complicating normal work of SRS.
|
|
|
|
|
- Remove a safety cushion of the driver.
|
- Turn out screws and remove the top and lower casings of a steering column.
- Turn out screws and remove the multipurpose switch.
|
|
- Installation is carried out to the sequences, the return to removal.
|
|
|
Check
With the multipurpose switch in each situation check conductivity between the corresponding contacts of sockets. If conductivity does not correspond to demanded, replace the multipurpose switch.
Lighting switch (M01-2 socket)
Switch of light of headlights (M01-2 socket)
HU: driving beam of headlights
HL: passing beam of headlights
P: dimensional lighting
Turn switch (M01-2 socket)
Screen wiper switch (M01-1 socket)
Windscreen washer switch (M01-1 socket)
Switch of forward fog lights (M01-2 socket)