15.7. Vacuum amplifier of brakes

Removal

 PERFORMANCE ORDER

  1. Disconnect brake tubes from the main brake cylinder.
  1. Remove the main brake cylinder. Inhaling moment: 8–12 N • m.
  1. Disconnect a vacuum hose from the vacuum amplifier of brakes.
  2. In interior of the car remove the spring forelock, and remove a pin with a head and an opening under the forelock.
  3. Turn off four nuts of fastening of the vacuum amplifier of brakes.
  1. Remove the vacuum amplifier of brakes.

Installation

 PERFORMANCE ORDER

  1. At installation of the vacuum amplifier of brakes remove transport packing from two parties of the amplifier.
  2. Establish the vacuum amplifier of brakes with new laying on a partition of a motor compartment and fix by four nuts. Inhaling moment: 13–16 N • m.
  3. Apply a lubricant layer on an adjusting opening in a brake pedal.
  1. Connect draft to a pedal of a brake and establish a pin with a head and an opening under the forelock and fix it by the new spring forelock.
  1. Install the main brake cylinder on the vacuum amplifier of brakes and fix by nuts. Connect brake tubes and tighten connecting nuts of fastening of tubes.
  2. From a motor compartment attach a vacuum hose to the vacuum amplifier of brakes.
  3. Fill a popolnitelny tank of the brake system with brake fluid. Remove air from a hydraulic contour of the brake system.
  4. Check lack of leak of brake fluid.
  1. Check and, if necessary, adjust height of installation of a pedal and a free wheeling of a pedal of a brake.
  1. After installation apply lubricant on points of contact of a pedal of a brake and draft.