13.5. Rack of a back suspension bracket

Removal

 PERFORMANCE ORDER

  1. Put back sitting.
  1. Turn out three nuts of the top fastening of a back rack.
  1. Remove a back wheel.
  2. Disconnect a brake tube and the sensor of frequency of rotation of a wheel from a back rack.
  3. Disconnect draft of the stabilizer of cross stability.
  1. Turn off nuts and get bolts of fastening of a rack to the fastener of a back axis.

Be careful not to damage a rack of a back suspension bracket.

  1. Get a rack from under a car wing.

Dismantling

 PERFORMANCE ORDER

  1. Special J38402 devices, – 20 and – 50 squeeze a spring of a rack of a back suspension bracket.

For compression of a spring use only the reliable tool.

  1. Turn off самоконтрящуюся a nut in the top part of a rod of the shock-absorber.
  2. Remove a rack support, a cylindrical spring and a dustproof cover.

Check

 PERFORMANCE ORDER

  1. Check a rack support for lack of wear or damages.
  2. Check rubber details for absence of damage or deteriorations in their state.
  3. Check a cylindrical spring for lack of a deflection and loss of elasticity.
  1. Check the shock-absorber for existence abnormal resistance or extraneous noise (see the Rack of a forward suspension bracket).

Assembly

 PERFORMANCE ORDER

  1. Establish the lower support of a spring so that its ledges entered plate openings of a spring.
  2. Install a dustproof cover on the shock-absorber.
  3. Special J38402,-20 and-50 devices squeeze a cylindrical spring of a rack of a back suspension bracket.
  4. After full compression of a spring install it on the shock-absorber.

Combine a D-shaped opening in the top support of a spring with lysky on a shock-absorber rod.

  1. Correctly arrange the top and lower ends of a cylindrical spring, having established them in dredging, and screw самоконтрящуюся a nut, but do not tighten it finally.

At assembly it is necessary to use new самоконтрящуюся a nut.

  1. Arrange a bolt of fastening of a support of a spring so that to combine projections of laying, as shown in the drawing.

The identification tag of a spring has to settle down from below.

  1. Remove J38402,-20 and-40 devices for compression of a spring.
  2. Tighten самоконтрящуюся a nut the required inhaling moment. Inhaling moment: 40–55 Nanometers.

Installation

Installation is carried out to the sequences, the return to removal.

After installation check the angles of installation of back wheels.